jimwright
Member
- Joined
- Aug 1, 2006
- Messages
- 9
- Reaction score
- 0
Hey Folks,
Looking to do an e-keggle project, maybe I'm overthinking it but I'm just wondering if I should try to cut the plastic coating off the top of this keg before marking and cutting the top hole or if I should just mark on the plastic and cut through it all.
I'm planning on using a dremel, should I just use that carefully to take the plastic off first?
Also this looks a bit different that most of the kegs I see on here, it says it's 13.2 gallon instead of 15 any inherent problems with using it for a kettle?
Thanks, I don't post much but I'd be lost in the brewing world without this forum.
Looking to do an e-keggle project, maybe I'm overthinking it but I'm just wondering if I should try to cut the plastic coating off the top of this keg before marking and cutting the top hole or if I should just mark on the plastic and cut through it all.
I'm planning on using a dremel, should I just use that carefully to take the plastic off first?
Also this looks a bit different that most of the kegs I see on here, it says it's 13.2 gallon instead of 15 any inherent problems with using it for a kettle?
Thanks, I don't post much but I'd be lost in the brewing world without this forum.