A friend was kind enough to give me a dual faucet shank which I would like to use in my kegerator to replace my single faucet tap. I currently have commercial kegs in there, but I am about to keg my first batch of homebrew (a kolsch) and I would like to serve two at the same time without drilling another hole in my fridge.
My problem is that the shank is missing the barbs that should extend at an angle from the end of the shank. The holes at the end are threaded and are exactly 1/4" in diameter. Perhaps a 3/16" threaded barb fitting would work?
I have talked to American Beverage Equipment and Kegco and a few other places without any luck in finding the replacement parts.
Any suggestions?
My problem is that the shank is missing the barbs that should extend at an angle from the end of the shank. The holes at the end are threaded and are exactly 1/4" in diameter. Perhaps a 3/16" threaded barb fitting would work?
I have talked to American Beverage Equipment and Kegco and a few other places without any luck in finding the replacement parts.
Any suggestions?