SHvanBommel
Well-Known Member
- Joined
- Nov 5, 2007
- Messages
- 548
- Reaction score
- 57
Yea, two hour drive would be more expensive than just buying full price.
Yea, two hour drive would be more expensive than just buying full price.
Just got an email from the board manufacturer that the boards have shipped.SHvB=3
KiwiRob=2
Schaze= 1
gromitdj= 1
This board will work with a RPI Zero?@bigdaddyale
Attached is a 4 pin (DS18B20) input, 8 output (12VDC) board.
not done yet as i need to label etc. but this is effectively where i'm at. 4 in, 8 out. if you need to, ou can compile your own kernel and use all 4 pins or use 1, up to the end user.
It's going to be bigger than the zero but yeah, assuming the same gpio connector (rev2) is on the zero.
http://www.nationalhomebrewclub.ie/forum/index.php/topic,15757.0.htmlthere was something on aussie and this Irish one was nationalhomebrewclub.ie i believe. I do not have history here so I can't check
What did I change?
Ok ,the boards just arrived today.I'll send you a PM with my paypal information and I'll need your snail mail address. $4.00 a board including shipping in the USA.SHvB=3
KiwiRob=2
Schaze= 1
gromitdj= 1
Ok ,the boards just arrived today.I'll send you a PM with my paypal information and I'll need your snail mail address. $4.00 a board including shipping in the USA.
I don't know much about pcb but this is the third time I ordered from DCPCB and every pcb is of high quality.The website can be a little hard to navigate and there is zero customer service but the product is excellent.Looks great!
Enter your email address to join: