Cleaning up after fabrication

[NCBeerMedic]

What is everyone using to clean their keggles/kettles after all the cutting and soldering? I thought about getting them up to 140-150 degrees and adding PBW and just circulating it through....Thoughts?

 

[NCBeerMedic]

anyone?

 

[cubalz]

All you have to do is scrub it good with regular Dawn dishwashing liquid and warm water. There is no need to get complicated with it.

 

[NCBeerMedic]

Thanks!

 

[Staticsouls]

I use bar keepers friend and a green scouring pad.

 

[day_trippr]

Second BKF. Make up a thick slurry and go to town. The PA will eat up a lot of fabrication crud...

Cheers!

 

[JDXX1971]

Yep, Bar Keepers Friend here too. I just did two tc ferrules in a keg this weekend and BKF makes short work of the clean up.

 

[ba-brewer]

My Brew bucket said use tsp to remove manufacturing residue.

 

[kevinthestout]

My Brew bucket said use tsp to remove manufacturing residue.

That's a different thing entirely. The TSP is to remove the oil that's applied as an anti-corrosion measure during shipping.

 

[golfindia]

I degrease/clean cut & solder spots with MEK and paper towels, and wash the whole kettle with Dawn.