2funkids
Active Member
I am looking for some advice on how to clean all my tap lines without a bunch of disassembly.
My thought is to daisy chain all the lines but I dont know how to attach the keg line out couplers together. I want to run a pump solution out of a 5 gallon pale of and into one of the 4 keg out couplers then through open tap #1. Then I want it to go from open tap #1 (with a larger id line that will slip over the Tap opening) to tap #2. The solution would go through tap #2 backwards to the next keg coupler. From this point I want to couple two of the keg out couplers together then the solution will go out tap #3 and in backwards through tap #4 where it would then go through the last coupler back into the pale. I am not sure how to do the plumbing? How are you all doing this task of cleaning the lines and taps? Is there a better way?
My thought is to daisy chain all the lines but I dont know how to attach the keg line out couplers together. I want to run a pump solution out of a 5 gallon pale of and into one of the 4 keg out couplers then through open tap #1. Then I want it to go from open tap #1 (with a larger id line that will slip over the Tap opening) to tap #2. The solution would go through tap #2 backwards to the next keg coupler. From this point I want to couple two of the keg out couplers together then the solution will go out tap #3 and in backwards through tap #4 where it would then go through the last coupler back into the pale. I am not sure how to do the plumbing? How are you all doing this task of cleaning the lines and taps? Is there a better way?