I just bought an older 2 pot burner stand with burners. It was left outside for a little bit and is now all rusted. What can I use to clean it and then possibly paint it?
Do I need to sand it down? If so, with what? I have a dremel with the wire brush attachment but i think that will gaugue it too much....
What do you think. I cant brew on something that looks so rusted and terrible
Do I need to sand it down? If so, with what? I have a dremel with the wire brush attachment but i think that will gaugue it too much....
What do you think. I cant brew on something that looks so rusted and terrible