atxstanley
Active Member
My immersion chiller has issues. It's a 30 foot copper chiller that I bought from AHS. When I hook it up to the sink and turn on the sink the hose blows off of the chiller and water goes everywhere. I took it back there and they swaped out the screw clamp fitting for a new one that went on tighter, but alas the new one blew off yet again. Is there a good fix for this? I can sweat copper fittings together but only want to do that as a last resort if nothing else works.
And to note, my sink does not have a very high pressure, the hose when it is clamped on is always relatively loose and can twist and slide around a little bit.
And to note, my sink does not have a very high pressure, the hose when it is clamped on is always relatively loose and can twist and slide around a little bit.