joyceman
Well-Known Member
I persistently get a haze on bottles that needs cleaned after every use. I posted a picture below, but Im not sure how well it comes through. I dont know the cause, but my water content and mineral buildup has been suggested. Im kinda doubt that Im the only one around here that has the issue when we all have the same public water, but I dont have any other workable answer. This is starting to drive me nucking futz.
The haze does not rinse out with hot water and requires some form of cleaning. A bottle brush with a little work does the job, but I dont enjoy brushing out 50-60 bottles every couple of weeks.
I've tried bbrite cbrite and oxyclean. They work, but only sometime. About 50% of the time they clean perfect with a rinse afterwards. 25% of the time it doesnt work at all and the remaining 25% of the time I end up with a white scale that I need to scrub off. I think I have the scale issue is nailed down (using too hot water), but I cant figure why sometimes they come out clean and sometimes they come out with no change. I use 1 tablespoon of the b&cbrite/ gallon for 24-48 hours. With Oxy I use 1 scoop/gallon for 24-48 hours. I use a bucket and clean 12-13 12 oz or 8 22 oz at a time in 3-4 gals of solution.
Anyone else with this issue? Anyone have any suggestions for easy cleaning this haze crap off my bottles ? Any ideas for whats up with the b/cbrite and oxy or suggestions for how to make sure this crap cleans every time? Bad mix ratio? Too much time? Too little time?
The haze does not rinse out with hot water and requires some form of cleaning. A bottle brush with a little work does the job, but I dont enjoy brushing out 50-60 bottles every couple of weeks.
I've tried bbrite cbrite and oxyclean. They work, but only sometime. About 50% of the time they clean perfect with a rinse afterwards. 25% of the time it doesnt work at all and the remaining 25% of the time I end up with a white scale that I need to scrub off. I think I have the scale issue is nailed down (using too hot water), but I cant figure why sometimes they come out clean and sometimes they come out with no change. I use 1 tablespoon of the b&cbrite/ gallon for 24-48 hours. With Oxy I use 1 scoop/gallon for 24-48 hours. I use a bucket and clean 12-13 12 oz or 8 22 oz at a time in 3-4 gals of solution.
Anyone else with this issue? Anyone have any suggestions for easy cleaning this haze crap off my bottles ? Any ideas for whats up with the b/cbrite and oxy or suggestions for how to make sure this crap cleans every time? Bad mix ratio? Too much time? Too little time?