Jbrew
Well-Known Member
- Joined
- Jan 17, 2017
- Messages
- 184
- Reaction score
- 19
I searched this a little on google and only found a little bit of info.
I’m doing a 120v 20amp controller. The controller is completely done and all that’s left is a heating element. I cant really decide.
I like that the boil coil is supposed to be less then ultra low watt density, does not stick out into the middle of the kettle, so my immersion chiller will sit on the bottom, and doesn’t require a very large hole that I’m nervous to cut into my kettle but rather just 2 5/8” holes.
The TC element on the other hand will allow me to remove it after brewday making for easier cleaning and it is a bit cheaper to set up.
Anyone out there that have had one or the other or both and which you like better?
Thanks all for advice.
I’m doing a 120v 20amp controller. The controller is completely done and all that’s left is a heating element. I cant really decide.
I like that the boil coil is supposed to be less then ultra low watt density, does not stick out into the middle of the kettle, so my immersion chiller will sit on the bottom, and doesn’t require a very large hole that I’m nervous to cut into my kettle but rather just 2 5/8” holes.
The TC element on the other hand will allow me to remove it after brewday making for easier cleaning and it is a bit cheaper to set up.
Anyone out there that have had one or the other or both and which you like better?
Thanks all for advice.