slakwhere
Well-Known Member
so i have a 50' 1/2" coil that i use as an IC, but i'm contemplating taking the old 25' IC and installing it into the HLT as a HERMS coil. the question is: where to put it in the HLT?
i assume i want to mount it as low as i can to minimize the amount of water needed in the HLT. that means drilling a couple holes and some compression fittings near the bottom.
output on the bottom and intake on the top so that it gravity drains, right?
ball lock on the bottom or top? needed at all?
should the 2 connectors be vertically aligned? is there some reason i'd want them offset?
anything else i gotta know before i punch holes?
i assume i want to mount it as low as i can to minimize the amount of water needed in the HLT. that means drilling a couple holes and some compression fittings near the bottom.
output on the bottom and intake on the top so that it gravity drains, right?
ball lock on the bottom or top? needed at all?
should the 2 connectors be vertically aligned? is there some reason i'd want them offset?
anything else i gotta know before i punch holes?