Hey guys,
I was curious if anyone has built a modular style approach to extending the beer lines (to balance your draft system)
Currently i have two beers in my kegs. Dale's Pale Ale and Jamil's dunkle. Both high co2 volume brews and i get some hellishly big foam, even after first poor.
My beer lines are 5ft.
I would like to build a couple of extenders that i can use to roughly gauge in the style of beer i have on tap. anyone done this arleady? Point me to the hardware to do it? A quick disconnect system would be awesome.
I've read the epic thread about the epoxy things you throw in the dip tubes but i'm thinking more along beer line only approach. I'm not to keen on the material composition of those things and rather not take a risk.
thoughts?
J
I was curious if anyone has built a modular style approach to extending the beer lines (to balance your draft system)
Currently i have two beers in my kegs. Dale's Pale Ale and Jamil's dunkle. Both high co2 volume brews and i get some hellishly big foam, even after first poor.
My beer lines are 5ft.
I would like to build a couple of extenders that i can use to roughly gauge in the style of beer i have on tap. anyone done this arleady? Point me to the hardware to do it? A quick disconnect system would be awesome.
I've read the epic thread about the epoxy things you throw in the dip tubes but i'm thinking more along beer line only approach. I'm not to keen on the material composition of those things and rather not take a risk.
thoughts?
J