Just ordered some Accuflex Bev-Seal line, 3/16" ID, and I'm going to want to connect it to my draft tower - a standard round riser with two faucets mounted to a Kegerator.
I also ordered the John Guest fittings for connection to the ball-locks at the keg, but for now I plan on connecting the other end of the lines directly to the small metal tubes coming out the back of the shanks inside the tower.
Question: Has anyone tried or better, succeeded in getting the JG fittings inside a standard round tower? I'm thinking the JG shank fitting to a JG 90; but would there be enough room?
The other option I'm considering ($$$) is getting a new tower with a T-configuration (stainless box on top of the round riser) - this would likely afford plenty of room to make that 90 with JG fittings, but I'd like to try it in my present tower first instead of shelling out $375 for a new tower.
EDIT - Just realized this should probably go in the Bottling/Kegging sub-forum, no? Please move if so.
I also ordered the John Guest fittings for connection to the ball-locks at the keg, but for now I plan on connecting the other end of the lines directly to the small metal tubes coming out the back of the shanks inside the tower.
Question: Has anyone tried or better, succeeded in getting the JG fittings inside a standard round tower? I'm thinking the JG shank fitting to a JG 90; but would there be enough room?
The other option I'm considering ($$$) is getting a new tower with a T-configuration (stainless box on top of the round riser) - this would likely afford plenty of room to make that 90 with JG fittings, but I'd like to try it in my present tower first instead of shelling out $375 for a new tower.
EDIT - Just realized this should probably go in the Bottling/Kegging sub-forum, no? Please move if so.