I purchased some ½ couplers to weld in some legally purchased kegs. The outer diameter of the couplings is 1.027.
I have a hydraulic hole punch that will cut a very clean 1.115 hole.
Will this size hole be too big for a welder to properly weld into my kegs? The welder would have to fill .088to .044 to install the couplings.
I am trying to avoid using a step bit, the punch is so easy to use.
Thanks,
John
I have a hydraulic hole punch that will cut a very clean 1.115 hole.
Will this size hole be too big for a welder to properly weld into my kegs? The welder would have to fill .088to .044 to install the couplings.
I am trying to avoid using a step bit, the punch is so easy to use.
Thanks,
John