1/6 Sanke + Coupler Height?

[Mac_rancher]

I'm looking to use a sanke coupler with ball lock qd's and I'm wondering how much total height with keg I'm looking at with that setup. Standard 1/6 sanke d keg. I have 29" of height in my kegerator.

 

[Broken Crow]

Sorry to keep you waiting... I don't have an overall height measurement but I hope this helps:
My sanke's have no valves as I'm using them for fermenters, but holding a standard coupler approximately where it would be attached, and having these ball lock adapters: Sanke Coupler Ball Lock Liquid Post Liquid
Here's the height above the keg collar: (approx. 5 1/4")

If that's too high, you could consider a low-profile coupler like this:
https://www.ontariobeerkegs.com/taprite-low-profile-d-ft44t.html

 

[Ki-ri-n]

If you do a low profile coupler, It adds about 1.75" to the height of the keg. And you can convert it to use ball locks.
How to convert a Perlick low-profile sankey tap to ball lock

 

[Mac_rancher]

Thank you for taking the picture.By the looks of it I would be cutting it pretty close. I did some more research again and came across this low profile coupler that I think I will give a try.

https://www.kegworks.com/low-profile-coupler-with-rotating-probe/