pentiumone133
Well-Known Member
- Joined
- Nov 13, 2012
- Messages
- 62
- Reaction score
- 7
Hi. Building a RIMS system and I dont want to permenantly hard wire my thermocouple probe to the back of the PID. I know thermocouple wire is kind of special, but I have some bad thermocouples with wires still on them i can use as pigtails. My question is, if this wire is so special, would adding a male/female disconnect between the TC and the PID cause an issue? I was thinking a typical headphone panel mount jack on the PID side and a headphone jack solder plug on the TC side.
Thinking this
http://www.amazon.com/dp/B0008JFHHO/?tag=skimlinks_replacement-20
and this
http://www.amazon.com/dp/B000ML4A2Q/?tag=skimlinks_replacement-20
Thinking this
http://www.amazon.com/dp/B0008JFHHO/?tag=skimlinks_replacement-20
and this
http://www.amazon.com/dp/B000ML4A2Q/?tag=skimlinks_replacement-20
Last edited by a moderator: