sarsnik
Well-Known Member
I'd like to reuse a 10psi regulator for my brew stand. I though that it was 3/8 female flared, but I took it off today and it had the orifice attached directly to it.
Would there be an issue running it to a 1/4" x 1/2" bushing into my black pipe manifold? Or is the orifice too restrictive, and should I just get a new regulator?
Would there be an issue running it to a 1/4" x 1/2" bushing into my black pipe manifold? Or is the orifice too restrictive, and should I just get a new regulator?