Anybody out there using propane or NG to heat their HLT? I'm thinking of going this route and have a PID control my burner via Honeywell's Y8610U. The only thing I'm worried about is that it will open and close the gas solenoid too frequently.
Also, I'm trying to find the best place to put thermowell's on my rig. I understand that placing the probe to maintain my mash temp should be at the HERMS coil exit before it heads back into the MLT. Should this be the only temp probe on my rig?
Also, I'm trying to find the best place to put thermowell's on my rig. I understand that placing the probe to maintain my mash temp should be at the HERMS coil exit before it heads back into the MLT. Should this be the only temp probe on my rig?