Hey folks: I am finally building the collar for my keezer. I was going to use 1X4s or 2X4s. I didn't want a difficult lift for the kegs. I took off the rear hinges , measured them and realized that I will not be able to refasten to the keezer. I will be able to screw into the wood w/ the top screws but the lower screws are too low for the wood and too high for the original holes. I could use 6" or 8" collar but prefer to keep it low. I know it will be hard to clean and pick up stuff from the bottom when a collar gets too tall. How do you extend the hinges to fit a 4" collar??? Would 2X2's work or are they too narrow for the shanks.
Thanks, Charlie
Thanks, Charlie