ThePonchoKid
Well-Known Member
The manual suggests to disassemble and clean, in order to remove all machining oils.
Has anyone tried to take these apart? They are insanely tight fitted. Even with the right gear and a steady hand it feels as if you could buckle the pot at any moment.
I think I'm just going to use soap and water and a brush, and perhaps boil.
What a buzz kill this is becoming
Has anyone tried to take these apart? They are insanely tight fitted. Even with the right gear and a steady hand it feels as if you could buckle the pot at any moment.
I think I'm just going to use soap and water and a brush, and perhaps boil.
What a buzz kill this is becoming