I also just kegged my very first brew (well first kegged brew) a few minutes ago. I didn't set it at 25, I turned it up to 15 and shook the keg as it filled and then let it go back down to 10, I left the gas on. When will this be drinkable?
Also I notice when I disconnected my "in" line for a moment the disconnect was leaking a bit, I assume as long as it is on the keg, this is not an issue.
When I look at all the parts used in the system, the gray disconnects concern me the most. These little buggers look like they will fail eventually and be hard to detect. As I do plan to have up to 4 kegs connected, I have a 4 line manifold, what should I do when one or more lines are not being used? Should I install an inline shut off valve on each line? or remove the line and plug the manifold?
I am hoping to have my second keg filled tomorrow, so I will be using the manifold, it currently has two plugs installed.