smittygouv30
Well-Known Member
When trying to tighten the NO block to the 2-way switch housing I clearly over tightened it and snapped the screw off inside the hole (see the second picture). Is there anything I can do at thos point or should I just ordered another switch?
Any magic tricks to remove a broken screw from inside the hole?
Should I just liquid nail the 2 together?
My genius solution was to move the contact block to the other side of the switch (see picture 2 the switch on the right is the one in question). I then realized that this probably reverses the on/off positions. I need the on to be on the right and off on the left as I already ordered and recorded my panel tags.
So really the question is how to I get the NO contact block to be on the other side now that there is a screw stuck in the mounting hole.
Any magic tricks to remove a broken screw from inside the hole?
Should I just liquid nail the 2 together?
My genius solution was to move the contact block to the other side of the switch (see picture 2 the switch on the right is the one in question). I then realized that this probably reverses the on/off positions. I need the on to be on the right and off on the left as I already ordered and recorded my panel tags.
So really the question is how to I get the NO contact block to be on the other side now that there is a screw stuck in the mounting hole.