I was hoping that someone might be able to help guide me on this one. I'm starting to assemble my gas manifold for my single tier brew stand that utilizes three bayou burners.
I plan to go propane tank> gas regulator> 1/2" black pipe.
From there I'll have it spit into three sections each being connected to the black pipe via a 1/2" ball valve. Exiting the ball valve ideally I'd liked to reduce everything down to 3/8" because that is what the orifices are that go with the burners.
The problem I'm running into is that all the needle valves I'm finding are 1/4". This has me scratching my head at all the extra bits and pieces I'm going to have to use to reduce it with.
The last part of my equation is that I plan to use soft copper pipe for the longer lines once it has left the ball valve. I've done a fair amount of searches on the forum to help with this but so far haven't come up with anything that matches up close enough to be useful.
Anyone else run into this problem that might be able to shed some light?
Thanks!
I plan to go propane tank> gas regulator> 1/2" black pipe.
From there I'll have it spit into three sections each being connected to the black pipe via a 1/2" ball valve. Exiting the ball valve ideally I'd liked to reduce everything down to 3/8" because that is what the orifices are that go with the burners.
The problem I'm running into is that all the needle valves I'm finding are 1/4". This has me scratching my head at all the extra bits and pieces I'm going to have to use to reduce it with.
The last part of my equation is that I plan to use soft copper pipe for the longer lines once it has left the ball valve. I've done a fair amount of searches on the forum to help with this but so far haven't come up with anything that matches up close enough to be useful.
Anyone else run into this problem that might be able to shed some light?
Thanks!