cheezydemon3
Well-Known Member
I was thinking about doing a small angled collar, just to pull picnic taps through.
I can't commit to tap real tap hardware and don't even need a collar, but I don't really want to open the freezer every time to pull a pint.
I am thinking:
Leave lid attached
Angle sides so that lid is "open" 3 inches at front.
Rectangular front to collar, angled sides.
Slots in front of collar to allow picnic taps to slide in.
Leave taps pushed in up to the actual taps.
Bad idea?
I can't commit to tap real tap hardware and don't even need a collar, but I don't really want to open the freezer every time to pull a pint.
I am thinking:
Leave lid attached
Angle sides so that lid is "open" 3 inches at front.
Rectangular front to collar, angled sides.
Slots in front of collar to allow picnic taps to slide in.
Leave taps pushed in up to the actual taps.
Bad idea?