lehr
Well-Known Member
Hi I'm new to brewing in fact I've never brewed before.. but I joined a club and watched a guy brew and said to myself I've got to do this so I made this stuff.
Thanks here are some more.
Hi I'm new to brewing in fact I've never brewed before.. but I joined a club and watched a guy brew and said to myself I've got to do this so I made this stuff.
HOW did you polish it to look that nice? Wow!
What type of tool do you use to make the flanged holes? Is it possible to make more of them but smaller in a drip tray? Not that it matters, your looks great, I was just wondering.
Linc
I have more time polishing those things than I do in the whole system.
First I grind them with a 3-m scotch bright deburing pad and then I go over them with a DA-grinder with 80 grit and keep working my way down until I get to 400 grit then I polish it with a big air polisher and buffing rouge.
I just felt something warm and sticky on my leg.
Mittler bros. sell the flanging tools I think the smallest one I have is 1/2 inch but I will have to check when I get home and let you know tomorrow...What size do you want...The set costs like $300.00.
Lehr
How can I say I hate you without it sounding rude?
Just kidding that's a beautiful setup, I'm jealous and your fabrication skills are top notch. You might like having sight glasses on your kegs. Damn they're so shiny my eyes hurt. I love polished stainless. I'm just not motivated enough to polish that much surface area.
Can you post a pic or two off topic on what other kinds of fabrication work you do?
-Ben
Could you give the measurements for that stand? I would love to make something just like it.. I have been looking for a good 2 tier plan..
thanks!
Pat,
the craftsmanship in this build is crazy, very nice work. can you take a pic of the burner support area without a keg on it, and also it looked like you used hurricane burners with 90 degree brass fittings, how did you orifice them.
once again, nice build
Nick
Enter your email address to join: