ScubaSteve
Well-Known Member
- Joined
- May 21, 2007
- Messages
- 3,673
- Reaction score
- 91
I see a lot of questions with people worried about damaging their heating element with an immersion chiller, melting their BIAB, etc. I haven't seen this done before, but WHAT IF you put some perforated stainless tube around the element with some room for circulation? I figure you'd still be able to reach a boil, you could probably even drill some of the holes out. Alternatively, I guess you could solder "roll bars" around the element and get the same effect.