cowstick
Well-Known Member
This is my MLT there are many like it but this one is mine.
Here is my ball valve setup only I did use the gromet that came with the cooler. In this order.
Parts list goes like this.
1/2 in to 1/2 in male barb
Ball Valve
7/8 in washer
O ring
1/2 by 2 inch nipple (he he)
Cooler Gromet
7/8 in washer cut to fit
1/2 in to 1/2 in female barb
Then the Manifold.
1/2 in SS Braid by 6 ft.
5x 1/2 in tees
All SS hose clamps.
It was a PITA to build the manifold. I bled, got poked several times by loose SS Braid frayed ends. But in the end it was well worth the blood and home brew and time.
Thank you to all the inspiration from everyone that posted theirs and gave me ideas.
Here is my ball valve setup only I did use the gromet that came with the cooler. In this order.
Parts list goes like this.
1/2 in to 1/2 in male barb
Ball Valve
7/8 in washer
O ring
1/2 by 2 inch nipple (he he)
Cooler Gromet
7/8 in washer cut to fit
1/2 in to 1/2 in female barb
Then the Manifold.
1/2 in SS Braid by 6 ft.
5x 1/2 in tees
All SS hose clamps.
It was a PITA to build the manifold. I bled, got poked several times by loose SS Braid frayed ends. But in the end it was well worth the blood and home brew and time.
Thank you to all the inspiration from everyone that posted theirs and gave me ideas.