Recent content by Zakit24

Another method I found useful was to get everything assembled for a section loosely and straight and then tighten each bolt one at a time while still keeping everything aligned. That way you can narrow it down to one joint that may need adjusting as apposed to several. It also helps the...

Yea i had the same issue for a few of mine. It took a combination of tightening some at an angle and then bending a few of them. The bending can be difficult but I just attached one of the longer beams to the side that needed bending and push on it.

Yes please

Sure thing! I'll get you more pics and specifications in the next two weeks or so. Have a wedding to go to and drink beers :) but I definitely will get you that info

Just finished mine! I'm just missing a few heat shields between the two halves and then a board to place the MT on top of. Thanks for all the help guys. Should brew with it soon and I'll update with any lessons learned.

Absolutely right! Screw heavy metal poisoning, it just tastes way too good :)

Dear San Diego drinker/brewer, Just because you added a **** ton of hops doesn't make it a good beer. Sincerely, Someone how likes balanced beers

While I wait for my first Lager to lager I think I'll play around with some ginger beer. One of the best drink I have had in a long time was a Moscow Mule on tap! The vodka was already mixed in and carbonated. Going to try a one gallon batch and then 5 if it turns out well.

Digital thermometer to install into my CC and "Brew Chem 101: The Basics of Homebrewing Chemistry" Hope it's good

Yes please

I would say it makes life a LOT easier. With milk you have to be careful not to overheat it and slowly get it to the desired temp. A double boiler really helped me do that. Otherwise there is a good chance of unevenly heating the milk I just put a smaller pot inside of a larger pot as my "double...

Yes please!

I am currently working on my Arduino controlled system as well, and it is coming along very well. I started out with an Uno and soon realized I would be needing many more output so I got the Mega and it is just the right thing. My set up is pretty different from the OP's in terms of all the...

I was originally trying to do the same thing by using buttons to provide the input, but I decided I didn't want to do the programming for it so I now use potentiometers and the map() function to dial my input times and temp. I just found it much easier than trying to get the buttons to be inputs.

I'm in