Recent content by shingle

I also use the brewpiless pcb I've also successfully loaded the latest brewmaniacex on the pcb with esp32. Any advice on whether BM supports OLED display? EDIT: I suspect it requires the following set to true in config.h. I'll recompile and try again.... #define LCD_USE_SSD1306 true

Hello, really keen to do this one. Struggling with the estimated colour. Based on the grains available to me from the local HBS, using the recommended 80% MO, 8% caramunich I, 8% light munich and 4% crystal malts I'm only hitting an EBC of 21.6 ( 8.7 Degrees Lovibond). Well short of 16L...

Just updated this morning. I've noticed a couple of issues. I've played with heating Hysteria and Manual modes. When enabling the mode the PID does not set the initial GPIO value. i.e. the PID will not turn the GPIO ON if the minimum temperature is not reached or the GPIO does not reflect...

You are correct. I had to revert to commit 249d4ea to successfully create a PID.

I don't seem to be able to convert a probe to a PID. When I enter a heat GPIOx to the probe I get the following log: The probe doesn't change to a PID and the GPIO setting didn't commit. I am able to add pump switches without any issues. Any idea?

Quick question about ADC for volume measurement. I've read the following guide: http://dougedey.github.io/2014/12/20/Volume_Setup/ Is the setup limited to the DS2450 ADC? A more readily available ADC in my neck of the woods is the MCP3008...

Hello. Just signed up. Love the forum, love this software. I currently have a simple digital thermostat controlling my dual element BIAB vessel. Each 2200W element is connected to separate circuits in the house as to not overload and therefore separate SSRs. The 2nd element is manually...