Recent content by Philip1993

PERLICK 425 & 500 SERIES FAUCET GROWLER FILLERS $9.99 https://www.keystonehomebrew.com/product/perlick-425-500-series-faucet-growler-fillers/

This. Also, there is phosphoric acid in soda. They give away tens of gallons on the plane.

10 pints or so and the taste is all but gone. But.... it still foams like crazy .

I had one like that. Nasty yeast. I kegged it and waited. 1 month later, same. 2 months later, same. Undrinkable. I forgot about it in the back of the fridge. 4-5 months later I needed a keg and was going to dump it. Seconds before I dumped, I decided to give it one last taste. Hooked up a...

Why? Describe the flavor?

Well, mine arrived and so far I'm not so sure. Pour: First three glasses have been 50% foam. First pour was immediately after install, foam expected. Second was it 2 hours, same. Third at 5 hours, same. Taste: All three tasted metallic. Similar to Becks, actually. Setup: Sweetwater 420...

I was about to place an order. Still no off flavors? Any change in the loss of carb?

Personally isn't the issue, inside the passenger compartment is. And scuba is slightly different. If a disk bursts, it doesn't instantly fill the passenger compartment with asphyxiating and/or potentially explosive gas. CO2 does the former, acetylene the latter. Of course I could be mistaken...

If I'm not mistaken, it's unlawful to transport gas cylinders inside a passenger vehicle.

Length of run matters too.

Anyone tried construction adhesive?

That's what I have, and it was ~$120 7 years ago...

Are you certain about that? If so, then why does code call for #6 wire (50A carrying) on a 220v/50A circuit? I'm not saying your wrong, but my understanding differ. For power to balance, 220V x 50A = 11KVA 110V x 25A x2 = 5500VA. Those are two very different animals, the latter...

I could use a little advice on this semi-beer related project. I'm installing a 120V/30A outlet (TT-30R) for a camper. I'd also like it to serve as an outlet for an electric HLT. I'm recycling pieces from an old hot tub feed. So far I have a 220V/50A breaker in the main panel and a...

LOL! I was searching for this for a non-beer related project, and I ended up back here at HBT. I guess no matter what, it all comes back to beer...