Recent content by gueykewl

Encoder

Looking at starting a Brewpi build. Will the Rpi3 (jessie) support multi chamber build?

If I were a commercial brewer I would definitely be watching my brew house efficiencies as it is an important factor in determining if I am making money or losing money. Since I am just a home brewer My number one priority is to make good, consistent beer. That being said there are quite a few...

Yes, I agree and do the same. I never could wrap me head around trub loss affecting est mash eff. Impossible to extract more out of grains than a congress mash yet Beersmith will calculate 100%+ est mash efficiencies.

I am no expert on brewing nor the intricacies of Beersmith but, personally, I don’t pay TOO much attention to what Beersmith says my Brewhouse Efficiencies are. Brewhouse Efficiencies are based on what you are bottling or kegging. Which changes due to post fermentation processes, i.e. dry...

The gases may mix initially but I am sure that CO2 will settle to the bottom. At least that is what my lungs tell me when I stick my head down into my chest freezer fermenter.

What upright freezer did you go with?

Please count me in! Sent from my iPad using Home Brew

Count me in please Sent from my iPad using Home Brew

Would you mind reposting controller diagram. For some reason I couldn't see it. Thanks Sent from my iPad using Home Brew

What type of wifi dongle were you using? What was your wifi setup process? Having trouble as we'll but haven't researched any fix yet, I just put everything together last night. Initially got everything working with the Ethernet cable then installed the wifi dongle (Edimax). I could putty/SSH...

I soldered in a programming cable to the board using: 5 Dupont wires soldered to circuit board and 5PIN F DIN connector. Cannot solder the wires until after I install the female DIN connector into the lid. RJ45 cable (ends cut off, and used 5 of 8 available wires) soldered to the 5PIN M DIN...