Andrewk311
Active Member
- Joined
- Nov 13, 2016
- Messages
- 36
- Reaction score
- 0
In many cases the multiple connections can be made by placing two wires onto a single component terminal. I can modify the diagram to show how this can work. In cases where that isn't possible, wires should be connected on terminal blocks.
Have you figured out how the element power / main power interlock works yet? It can be confusing, unless you are adept at reading schematics.
Brew on
If you could show that on the diagram that would be awesome! I somewhat figured out how the interlock works, mainly because the hot wire in only goes to certain components. I will probably end up buying an additional bus terminal for all the neutral lines because I don't think I can fit that many in to one side of the din rail terminal block.