I have a 3/4 HP blower motor that I want to use for my new MM2.2 Mill.
On the wiring diagram it has 3 speeds but I don't know if using the lowest speed will drop the HP and torque too low. I also have not been able to figure out what the actual RPM would be at each of the speeds to know what size pulleys to get.
Here is a pic of the label:
On the wiring diagram it has 3 speeds but I don't know if using the lowest speed will drop the HP and torque too low. I also have not been able to figure out what the actual RPM would be at each of the speeds to know what size pulleys to get.
Here is a pic of the label: