What's the gap in your barley crusher? Just got my mill

[Mattbastard]

When you guys measure your gap, are you just sliding the feeler gauge into the gap without the rollers spinning, or are you having to force them down? I noticed I can have a variance of over .01" between either sliding the feeler gauge down, to making them spin and barely getting the feeler through.

 

[Elshauno]

I'm at .042 on a Monster Mill 2 and I consistently get 85% eff. batch sparging. I check the gap before every crush as I have some issues with one of the thumb set screws loosening regularly.

Try using some locktight you shouldnt have any more problems

 

[CrystallineEntity]

Had my BC mill for a while, but just getting around to using it. Measures .035 on one side and tighter on the other. I'm gonna set it for .035 (cause that's the largest feeler gauge i have). Got my coleman extreme set up with a Bargain Fittings braid. If I get a stuck sparge, I'm blaming Bargain Fittings, lol...

-Aaron