Weld-b-gone instructions?

[NomNom]

Hey guys,

I just got the basic weld-b-gone fitting for my keggle but it didn't include any instructions. Can someone fill me in on washer and bolt placement as well as if I should use teflon tape. Thanks!

 

[samc]

o-ring, nut, ball valve attached to nipple on outside - inside washer then coupler attached to nipple. Hand tighten from the inside and then use an open end wrench/pipe wrench or something else and tighten nut on the outside. I did not use teflon, should not be needed as the o-ring and washer should be stopping the liquid. Test for leaks before brew day.

Hopefully my memory is correct.

 

[Boerderij_Kabouter]

Bargain Fittings

I don't use the second o-ring on the inside of the kettle because I think you loose rigidity and don't get a better seal. Many use that arrangement to great effect.

 

[NomNom]

Thanks a lot!