Tower of Power HELP

[rpastor]

Sorry for posting twice, but my title wasn't clearly stated. When I start my Breweasy system, the solenoid kicks in, gas flows, and ignites. After 7 seconds, the solenoid clicks, the flame goes out and I get an alarm. This happens in both Auto and manual. I have disconnected and reconnected everything with the same problem. The system was only used twice (successfully), kept inside, and not exposed to heat. I was all set to brew this morning so I need help ASAP. I don’t want to lose my 2 L starter. Thanks for any help.

 

[Wonputt]

I would try adjusting the gas flow. It might be too high causing flame blow out? Or even too low?

 

[rpastor]

I got on the phone with Blichmann and found the problem (bad ignition cable). I was able to brew using the Breweasy by manually turning the burner on and off at the proper temperatures. They are sending me a new cable.