I am getting two more sight gauge/thermometer combos from weldeless fittings. My question is how long must the thermometer probe protrude into the pot (not how long should the probe be).
1) HOW FAR INTO THE KETTLE SHOULD A DIAL THERMOMETER GO?
2) DOES BLICHMANN MAKE LONGER STEM THERMOMETERS?
I want the blichmann (fun to see the mash temps, etc) but I don't believe 6" stems are made by blichmann, only 2"...otherwise I will get the 6" stem from weldless IF NEEDED.
long time no post...thank you again everyone!
1) HOW FAR INTO THE KETTLE SHOULD A DIAL THERMOMETER GO?
2) DOES BLICHMANN MAKE LONGER STEM THERMOMETERS?
I want the blichmann (fun to see the mash temps, etc) but I don't believe 6" stems are made by blichmann, only 2"...otherwise I will get the 6" stem from weldless IF NEEDED.
long time no post...thank you again everyone!