I have 2 SS Brewtech 7 gallon conical fermenters with the FTSS temperature controller kits. The lids that come with the kit are flat with 4 holes: 2 for the cooling coil, 1 for an airlock/blow off tube and one for the thermowell. See the underside below.
I recently bought the FTSS controller brackets so I can mount my controllers on the front of the conical using that thermowell instead of the thermowell in the lid. My preference would be to remove the thermowell in the lid and seal the hole rather than leave it in place. Any suggestions on how to seal it without it looking like a hack job? Thanks.
I recently bought the FTSS controller brackets so I can mount my controllers on the front of the conical using that thermowell instead of the thermowell in the lid. My preference would be to remove the thermowell in the lid and seal the hole rather than leave it in place. Any suggestions on how to seal it without it looking like a hack job? Thanks.
Last edited: