DrugCoder
Well-Known Member
I need to drill a port in my keggle and I don't have a step bit. Is there a favorite brand or retailer out there that you prefer? Any particular kind of step bit I need to look for to drill a hole for a 1/2" port?
I should get some thread cutting lubricant, but Pam spray has always worked...
I should get some thread cutting lubricant, but Pam spray has always worked...
I was thinking of using WD40...
Too light most likely. Better than water, but not much. You really need something a little heavier. Even light machine oil works well for drilling.
I've got some 5w30 and 10w30 motor oil...too heavy?
Nope. They would both work just fine...