STC 1000 Project Box Wiring

[Mike_McBrew]

I'm about to build my kegerator and have received the parts for the STC1000 project box. Based on the info available I've made the following wiring diagram (AutoCAD it is not). Have I understood correctly?

The lamps are just for a quick visual check that everything is working as expected.

Thanks,
M

 

[jbb3]

I didn't check your diagram but here's a proven diagram minus the lamps if you want a sanity check.

 

[Mike_McBrew]

I didn't check your diagram but here's a proven diagram minus the lamps if you want a sanity check.

Thanks.
Essentially then, everything is in parallel?
My lamps are in parallel (I think) with the cooling (hot) / heating (hot) circuits and the single neutral circuit - is that correct?

 

[day_trippr]

The original diagram is functionally correct - if visually jarring -
though the "On/Off" lamp is more of a "pilot" as there's no "master switch" between the power source and the controller...

Cheers!

 

[Mike_McBrew]

The original diagram is functionally correct

Thank you

if visually jarring

I agree
PowerPoint is not Autocad

though the "On/Off" lamp is more of a "pilot" as there's no "master switch" between the power source and the controller...

Yes, I may put a switch just before the first two splicers.

Thanks again,
M

 

[jbb3]

The original diagram is functionally correct - if visually jarring -
though the "On/Off" lamp is more of a "pilot" as there's no "master switch" between the power source and the controller...

Cheers!

Which is why I didn't check it. The diagram is a little on the busy side... But sometimes it helps to draw things out to get it straight in your mind. Even if the drawing method is difficult for others to follow.

I also agree the on/off light seems useless. Even if you add a switch, given the display on the STC is always lite (and doesn't have a sleep mode), if the display is lite, it's on...