After reading the advice I got in a prior thread I hooked it all up. The link (or image if it comes through) below shows how I have it hooked up. But, now I have another problem.
Once I get everything hooked up I set my primary to 35psi. Pressure is going through the high side all the way through both secondary’s, however, there is no pressure going to the low side on either of the secondary regulators. I open up the low side valves on both secondary’s and nothing. I tried turning the screws on both secondary’s all the way up and still nothing. Do I still not have this hooked up correctly?
Once I get everything hooked up I set my primary to 35psi. Pressure is going through the high side all the way through both secondary’s, however, there is no pressure going to the low side on either of the secondary regulators. I open up the low side valves on both secondary’s and nothing. I tried turning the screws on both secondary’s all the way up and still nothing. Do I still not have this hooked up correctly?