Regulator add ons

[Skipster]

I have seen pictures of regulators that have a primary and a secondary, even seen a few that have 4 or 5 inline.

My question is how does a guy go about doing this. I would really like to just purchase the secondary and add it on if that is possible. I want to run a single line into my Sanyo and have a couple of regs. It would make carbonating a hell of a lot easier. Any ideas?

 

[Skipster]

Sorry to bring this back up guys, but I have had no luck. The welding supply stores near me are not helping at all. Do I just need to buy a setup that has the 2 regulators on it? Or has anyone had success adding a second one on?

 

[Shonuff]

No need for a dual reg. all you need is this

found at

http://stores.kegconnection.com/Detail.bok?no=51

 

[david_42]

Secondary regulator discussion and examples.
www.homebrewtalk.com/showthread.php?t=9650

 

[Denny's Evil Concoctions]

Jester has like 7 on his. I have the regs just haven't put them in line yet.

Take the main reg, and feed off the output if the regs you have are secondaries. (My secondaries are rated 1800psi so I can in fact use them as primaries). Or if they are all high pressure rated then you could just t them off a main connection.

Check out Jester's picks. He has some in his gallery. https://cdn.homebrewtalk.com/gallery/showphoto.php?photo=4771&cat=all&ppuser=7674