jlogue3454
Well-Known Member
So I needed a new wort chiller to fit my upgraded kettle. I decided to go all out and just get quick disconnect fittings. I'll post some shots of it in action tomorrow
It started out life as a simple coil...
Here it is once I coiled it around one of my corny kegs.
Had to get a bigger tubing bender to make those bends on 1/2 in copper.
Here it is with the fittings, the chiller was so heavy it began to collapse on itself.
I can't wait to give this thing a test run.
It started out life as a simple coil...
Here it is once I coiled it around one of my corny kegs.
Had to get a bigger tubing bender to make those bends on 1/2 in copper.
Here it is with the fittings, the chiller was so heavy it began to collapse on itself.
I can't wait to give this thing a test run.
