I'm wiring a switch in between my pid and my element. I know the ssr could still fail closed, but until I get a relay I'm going to use this setup. I can always unplug the element from the panel.
My question is, how do I wire the switch in this situation? It's a pushbutton LED from automation direct.
I wired the + from the pid to the contact block top. Then I wired the load wire to the + on the SSR and jumped it to the body of the switch.
Next I should wire the neutral to the switch body. but do I wire the (-) wire from the pid to this or the 120v neutral? If it is the 120v neutral, I assume (-) from the pid right to the SSR?
It has to be 120v to switch body and (-) to SSR, right?
Thanks guys.
My question is, how do I wire the switch in this situation? It's a pushbutton LED from automation direct.
I wired the + from the pid to the contact block top. Then I wired the load wire to the + on the SSR and jumped it to the body of the switch.
Next I should wire the neutral to the switch body. but do I wire the (-) wire from the pid to this or the 120v neutral? If it is the 120v neutral, I assume (-) from the pid right to the SSR?
It has to be 120v to switch body and (-) to SSR, right?
Thanks guys.