Question about Towers??

[EcuPirate07]

Can I use this tower with my corny set up? http://www.beveragefactory.com/draftbeer/towers/doublefaucet/D4743DT___6843.shtml It says it comes with line and hex nuts to connect but I dont need the hex nuts since thats not how my connections are set up. So would I just cut the line right above the hex nuts then clamp it to the connections? Im just trying to figure this out before I was my time and money ordering it and then not being able to use it. Cause on their sit all their "homebrew kits" are single fct towers and I want a double fct tower. Thanks for the help guys!

 

[Bowtiebrewery]

Yes that Tower is fine for you... You can just cut the hex nut off but keep that for possible future brewing expansion... then just push the 3/16" line onto a Corny keg beer out post and clamp down with Oetinger or crimp clamps.

 

[mplutodh1]

If you are open to a little DIY - check out the link in my signature - I wasn't happy with the quality of the towers I saw pre-made so took a different route - much sturdier in my opinion. You might spend a few bucks more up front but you'll end up with a nice quality, with your choice of faucets and hardware - less likely to want/need to upgrade in the future.

ACU is Acu Metal Fab http://www.acumetalfab.com/products1.html

 

[Ricand]

I would see if they have an upgrade to forward sealing faucets. They stay cleaner and don't stick if you don't use them for a while. Perlick's new series isn't that much more expensive.

Cheers,
Rick

 

[EcuPirate07]

Thanks for the info guys