Just completed the first brew using my new ebiab system. I based it on mrBippers http://www.instructables.com/id/Electric-brewing-system/ and of course http://www.theelectricbrewery.com/.
I couldn't have gotten this far without all the great info on this forum. Anytime I got stuck or needed some reassurance I just searched here and found the answer. Thanks to everyone.
The controller uses a Mypin td4 PID and a Liquid Tight RTD Sensor, 2” Probe, Weldless Fitting from Auberins.
My brewpot is a Concord 60 qt stainless with one 5500 watt ULWD element.
Nice cream ale mashing in.
Mash held right at 149.
Came up to a good boil with no problem.
Being my first brew with the new system it needs a little dialing in but all in all I was very pleased with the performance.
BTW.. The dog's not dead... Just not that impressed.
I couldn't have gotten this far without all the great info on this forum. Anytime I got stuck or needed some reassurance I just searched here and found the answer. Thanks to everyone.
The controller uses a Mypin td4 PID and a Liquid Tight RTD Sensor, 2” Probe, Weldless Fitting from Auberins.
My brewpot is a Concord 60 qt stainless with one 5500 watt ULWD element.
Nice cream ale mashing in.
Mash held right at 149.
Came up to a good boil with no problem.
Being my first brew with the new system it needs a little dialing in but all in all I was very pleased with the performance.
BTW.. The dog's not dead... Just not that impressed.