So I spotted this on Amazon https://www.amazon.com/Electric-Grinder-Stainless-Crusher-Cereals/dp/B08CN8RWZX/ it seems like a good deal $178 for motorized mill and was wondering if anyone had tried it.
So I spotted this on Amazon https://www.amazon.com/Electric-Grinder-Stainless-Crusher-Cereals/dp/B08CN8RWZX/ it seems like a good deal $178 for motorized mill and was wondering if anyone had tried it.
Yeah, that's the only obvious drawback. But then, you can load it up, and go do something else useful while it does its thing.Can't argue that last point, but to me that thing would be painfully slow vs my 180rpm CK mill...
Cheers!
0 to 2.5mm (0 to 0.065".)The description states that the rollers have "an adjustment range of 2.5mm," but doesn't say what the low end of that range is. For all I know, it could be 2.5-5.0mm. But if I knew the gap could be set to below 1mm, I'd be tempted to pull the trigger on one.
Gap adjustment method isn't obvious. Listing says "Stainless knurled knobs allow a gap spacing adjustment range of 2.5mm. Adjusting is simple - just loosen the adjustment screws, adjust the gap and tighten the adjustment screws. "I suppose, but by their specs my typical 10 gallon ales would take a half hour to mill.
btw...check out these gap adjusters. That looks hinky - are you supposed to pry some sliding bearing block or what?
ps: there's an image that suggests it's capable of a 0 to 0.065" gap...
This one uses that same image, is the same price, but suggests a larger hopper.
Same Mill with 11 lb grain hopper
This one uses that same image, is the same price, but suggests a larger hopper.
Same Mill with 11 lb grain hopper
It states in a picture that the range is between 0 and .065"The description states that the rollers have "an adjustment range of 2.5mm," but doesn't say what the low end of that range is. For all I know, it could be 2.5-5.0mm. But if I knew the gap could be set to below 1mm, I'd be tempted to pull the trigger on one.
It states in a picture that the range is between 0 and .065"
Enter your email address to join: