joydivision
Active Member
I just built my own mash tun but it leaks by the spigot/connector. Does anyone know a good way to seal it?
Some possible solutions that have been running through my head:
Use a larger brass nipple
My connectors don't screw all the way to the valve or pipe tee, even when I use a wrench. Buy new connectors.
I have the rubber ring from the original plastic spigot inside the cooler should I put another one outside the cooler?
Some possible solutions that have been running through my head:
Use a larger brass nipple
My connectors don't screw all the way to the valve or pipe tee, even when I use a wrench. Buy new connectors.
I have the rubber ring from the original plastic spigot inside the cooler should I put another one outside the cooler?