Mash And Boil Replacement/2nd Lid Options (RoboBrew or Grainfather??)

[toms_Jeep]

I did try searching and was not able to find any information on getting a replacement lid for my Mash and Boil.

I didn't want to cut my original lid but I want to find a replacement lid that I can cut 2 holes in for use during mashing. 1 hole will be for my sparge arm that I use to recirculate during mashing, the 2nd hole will be for my wort chiller when done with the boil.

 

[TwistedGray]

I bought my fermentation lid from amazon, but you can buy it here (https://www.williamsbrewing.com/Mash-Boil-Still-Lid-P4432.aspx) for cheaper. It already has one hole, so you'd just need to cut out the second.

 

[toms_Jeep]

I bought my fermentation lid from amazon, but you can buy it here (https://www.williamsbrewing.com/Mash-Boil-Still-Lid-P4432.aspx) for cheaper. It already has one hole, so you'd just need to cut out the second.

Thank you..
I will measure my SS BrewTech Sparge Arm tonight to make sure it will go through that center hole.

 

[TwistedGray]

Thank you..
I will measure my SS BrewTech Sparge Arm tonight to make sure it will go through that center hole.

No problem

 

[brewman !]

I bought my fermentation lid from amazon, but you can buy it here (https://www.williamsbrewing.com/Mash-Boil-Still-Lid-P4432.aspx) for cheaper. It already has one hole, so you'd just need to cut out the second.

You generally can't cut tempered glass without it shattering.

 

[toms_Jeep]

You generally can't cut tempered glass without it shattering.

The Mash and Boil lid I have is stainless steel, so that won't be an issue.