Pol, I'm really interested in your wireless bridge. I have my BCS built onto a panel, and the rig is in my detached shop. I have wireless in the shop but no wired connection to the house so I have to be in the shop to connect to the BCS. That is not a problem on brew days, but it would be more comfortable to setup pids, processes, etc, in the house, then go to the shop for testing.
I started some wet tests last night, I'll be interested in your feedback when you get to that point. I'm gonna brew Saturday... will most likely be in the Manual Mode. I'm not expecting great results (I think the BCS will do fine, but I don't have all the info for the calculations... losses, etc.).
I found that in manual mode, after you make a change, you have to hit the "apply" button... so to turn off a pump, you hit direct off, then apply, then there is a slight delay, then the pump goes off.
Also, looks like the manual mode "fights" with the Output buttons on the top of the Main screen... So, if you are in manual mode with a pump (or heater) on, and you hit the Lighted Output button, you get a slight delay, then the pump goes off, then a delay and the pump comes back on! This is kinda obvious with a pump because you can hear it, not so clear with an element.
I'm certainly no expert, so maybe I missed something... Oh well, guess I'll go re-read the manual... wait a minute there is no manual
Guess I'll go bouncing around the wiki.
BTW... Congrats on a beautiful build... can hardly wait to hear about it in action.