I succeeded in cutting the top of a keg open, but unfortunately I cut it slightly smaller than I would have liked for a tight fitting lid. So I am around a quarter inch short all the way around (see attached picture). Any suggestions on how I can make the hole wider?
I cut the top off using 6 reinforced metal cutting bits with a Dremel. I would rather not have to go that route again if possible.
Thank you for your thoughts and suggestions.
I cut the top off using 6 reinforced metal cutting bits with a Dremel. I would rather not have to go that route again if possible.
Thank you for your thoughts and suggestions.
![Keg Top.jpg Keg Top.jpg](https://cdn.homebrewtalk.com/data/attach/126/126709-Keg-Top.jpg)